Shall be a Crown models, convection
steamer on a modular, gas fired, steam boiler base, with stainless
steel type 304 exterior and #4 finish. The steamer shall have doors
with removable inner liner of stainless steel, fullperimeter gasket seal,
outer shell of one piece all welded stainless steel, positive lock and seal
mechanism and a stainless steel drip trough connected to a drain to
collect condensated when doors are opened. Each cooking chamber
shall be constructed of all welded type 316 stainless steel, fully insulated
and provided with removable stainless steel pan supports and shall be:
GCX-2, 13.875” W x 10.875” H x 19.875” D (352 mm x 276 mm x 504 mm).
GCX-10, 13.875” W x 17.375” H x 19.875” D (352 mm x 441 mm x 504 mm).
Control housing shall be accessible through a fully removable side panel
and each compartment shall include a 60 minute mechanical timer with
ready pilot and cooking pilot light and an audible signal which will sound
at the end of the cooking cycle. Steam flow to the chamber shall be
interrupted when the compartment door is opened during cooking cycle
and shall be reactivated when the door is closed.
The convection steamer shall be mounted on a cabinet base with
full perimeter angle frame, reinforced counter and boiler mountings,
gas boiler with controls, all stainless steel exterior, hinged door(s)
with magnetic latch and 6” (152 mm) stainless steel legs fitted with 4
adjustable flanged feet for securing unit to the floor. Standard boiler
controls shall include automatic water level control, pressure gauge,
water gauge glass, operating pressure control, safety hight-limit pressure
control, safety relief valve and cathodic protector. Unit comes standard
with a split water line, CSD-1 boiler controls, electronic ignition, nickel
plating, automatic blowdown, and water treatment system.
The unit shall be ASME code stamped and National Board registered,
AGA, CGA and NSF certified.