Crown Two Compartment
24 Pan Steamer
with Cabinet Base
SPECIFICATIONS:
Shall be a Crown model GCX-24 convection steamer with gas
steam boiler. The steamer shall be constructed of satin finish
stainless steel, type 304, with a cooking chamber of one piece
all welded 316 stainless steel. The doors shall have a removable
inner liner of stainless steel with full perimeter gasket seal, an
outer liner of one-piece all welded stainless steel and a positive
lock and seal mechanism. The door opening shall be 17.625” x
26.75” (448 x 680mm).
The steamer shall be provided with removable stainless steel
pan supports and a stainless steel drip trough connected to the
drain to collect condensate when door is opened.
The control housing shall be constructed of stainless steel with
a full access removable panel. The timing of each cooking
compartment shall be independently controlled by a “60” minute
timer, a green ready pilot light and a red cook pilot light. At the
end of the cooking cycle an audible signal is sounded. Steam
flow to the cooking chamber shall be interrupted when the door
is opened during the cooking cycle and shall be reactivated
when the door is closed.
The convection steamer shall be mounted on a cabinet base
with full perimeter angle frame, reinforced counter, and boiler
mountings, gas boiler with controls, all stainless steel exterior,
hinged doors and 6” (152mm) stainless steel legs with 4
adjustable flanged feet for securing to the floor. Water treatment
system, automatic blowdown, CSD-1 boiler controls, electronic
ignition, and split water line are standard.