The Delfield CAB2-1200ET Mobile Enclosed Two-Stack Dish Dispensers
Delfield CAB2-1200ET Specification
Cabinet
Cabinet top shall be 16-gauge stainless steel with all corners welded and
polished and reinforced with heavy-gauge channels. Cabinet exterior panels
and corner support angles shall be 20-gauge stainless steel. Unit shall
have four 4.00" (10cm) diameter polyolefin swivel casters (all locking),
and non-marking gray bumpers at each corner
Dispenser
Dispenser tube shall have 3 vertical side channels and a bottom brace of
22-gauge stainless steel. Top supporting flange shall be 18-gauge
stainless steel. Flange, channels and bottom brace shall be integrally
welded together. Flange shall have 3 guide posts molded from high impact
plastic.
Self-leveling Mechanisms
Self-leveling mechanisms shall be field adjustable by adding or removing
stainless steel extension springs on perimeter of vertical side channels.
The dish carrier head shall be stainless steel welded rods with a
removable 18-gauge stainless steel top plate.
Capacity
Capacity of tubes shall be approximately 72 dishes, with a maximum
stacking height of 24.00" (61cm). Models without “-ET” or “-QT” suffix are
unheated.
Electrical Connection
Unit shall be supplied with 9' (2.7m) cord and NEMA 5-20P plug. Electrical
connections shall be 120 volt, 60 hertz, single phase. Each tube shall
have its own convection heating module consisting of a single 400 or 700
watt heating element and fan motor, located in the center of the interior
bottom cavity. Air intake shall have a filter. Each tube shall have an
adjustable thermostat inside the motor housing and an ON/OFF switch on one
of the dish guide posts. Unit shall maintain temperature between
120°F–140°F (49°C–60°C).
Delfield CAB2-1200ET Standard Features
Cabinet top to be 16-gauge stainless steel
Outer body and corners to be 20-gauge stainless steel
Non-marring gray corner bumpers
(4) 4.00” locking polyolefin swivel casters
Dispenser top flange, vertical side channels and bottom brace are
stainless steel
Dispenser flange, channels and bottom to be integrally welded
CAB2-1200ET: 2 stack even temp heated dish dispensers
Spring supports to be 14-gauge S/S
Carrier head made of welded rods with a removable 18-gauge top plate
Field adjustable self-leveling mechanism
High impact plastic guide posts mounted to flange
One year parts and 90 day labor warranty Heated, QT & ET, Features
9’ cord and plug
Convection heating module and fan motor per dispenser