The Delfield N8656P Drop-In Self-Contained Hot & Cold Combination Pan
Why Use Delfield's Drop-In?
Safety and Sanitation
UL and NSF - All Delfield Drop-in products are UL approved and NSF
certified. Which means you can count on safe, consistent construction and
performance every time.
Convenience
Delfield Drop-in products are easy to install into any new or existing
counter. A press fit flange gasket comes pre-installed making the units
ready to drop-in immediately.
Quality
Delfield Drop-in products have an unmatched level of quality. The units
are reliably built by the best in the industry and come standard with a
90-day labor and 1-year parts warranty
Construction
Delfield Drop-in products are constructed with stainless steel tops and
interiors. Cold units are insulated with high-density polyurethane foam
and hot units are insulated with fiberglass.
Refrigeration lines are secured to the liner with stainless steel spot
clips and thermal transfer compound is applied to improve heat transferred
cool the food product better.
Delfield N8656P Standart Features
High density environmentally friendly, Kyoto Protocol compliant, Non ODP
(Ozone Depletion Potential), Non GWP (Global Warming Potential)
polyurethane foam throughout
N8656P: 56” hot & cold combination pan drop-in
NSF-4 and NSF-7 certified for hot and cold operation
Stainless steel immersion heaters
Remote control panel with 3-way hot/cold/ off power switch and
thermostat for hot operation
Thermostat for cold operation located next to condensing unit
Adjustable pan support for flush mounted hot operation or 2” recessed
cold operation
1’’ stainless steel drain with screen
Stainless steel louver provided
Push-in flange gasket is standard
Adaptor bars for 12”x20” pans provided
Environmentally friendly HFC-404A refrigerant
Standard 90 day labor and one year parts warranty
Additional adaptor bars or plates
Delfield N8656P Specification
Interior: Interior liner is constructed of stainless
steel with a 1” (2.5cm) drain. Adjustable stainless steel pan rest for
flush mount heating or 2” (5cm) recessed cooling to accommodate up to 6”
(15cm) deep 12”x20” pans, supplied by others. Stainless steel immersion
heater(s) installed in bottom for wet only heating operation
Exterior: Exterior body is constructed of galvanized
steel with high density environmentally friendly, Kyoto Protocol
compliant, Non ODP (Ozone Depletion Potential), Non GWP (Global Warming
Potential) polyurethane insulation throughout.
Refrigeration: Condensing unit is suspended on a
galvanized steel frame. Environmentally friendly HFC-404A refrigerant is
utilized. Temperature controlled by thermostat located next to
condensing unit
Operation: Remote control panel contains 3-way
Hot/Cold/ Off power switch and thermostat for heated operation. As a
safety feature, the food well immersion heater includes a high limit
safety switch. If the heater gets too hot the safety switch will trip,
turn the heater off and illuminate a control panel pilot light.
Electrical: All units must be hard wired at
installation.
Top: Top is constructed of one-piece stainless steel.