The Delfield SFW-2-NU Mobile Hot and Cold Combination Serving Counters
Delfield SFW-2-NU Specification
Exterior Top
Exterior top is constructed of 14-gauge stainless steel, welded, ground
and polished into one integral unit. Top is fabricated with square
exterior corners.
Interior
Interior liner is constructed of stainless steel with a 1” (2.5cm) drain.
Adjustable stainless steel pan rest for fluch mount heating or 2” (5cm)
recessed cooling to accommodate up to 6” (15cm) deep 12” x 20” plans,
supplier by others. Stainless steel immersion heater(s) installed in
bottom for wet only heating operation.
Exterior Body
Exterior body is constructed of 18-gauge stainless steel side panels and
14-gauge galvanized bottom. All exterior side panels are reinforced with
overlapping corners and are welded in place. All body cutouts are
reinforced with 14-gauge galvanized channel supports.
Casters
Casters unit is mounted on 5” (13cm) diameter swivel casters with
non-marking polyurethane casters and pate brakes. Overall height of caster
assembly is 6” (15cm)
Delfield SFW-2-NU Standard Features
High density environmentally friendly, Kyto Protocol compliant, Non ODP
(Ozone Depletion Potential polyurethane foam throughout
NSF-4 and NSF7 certified for hot and or cold operation
Wells operate independently for hot or cold operation and vice versa
Stainless steel immersion heaters - one per well
Control panel(s) with 3 way hot/cold/off switch and thermostat for hot
operation
Electronic temperature control
Adjustable pan support for flush mounted hot operation or 2” recessed
cold operation
The image above may not exactly represent the product
