The Delfield SFW-5-NU Mobile Hot and Cold Combination Serving Counters
Delfield SFW-5-NU Specification
Exterior Top
Exterior top is constructed of 14-gauge stainless steel, welded, ground
and polished into one integral unit. Top is fabricated with square
exterior corners.
Interior
Interior liner is constructed of stainless steel with a 1” (2.5cm) drain.
Adjustable stainless steel pan rest for fluch mount heating or 2” (5cm)
recessed cooling to accommodate up to 6” (15cm) deep 12” x 20” plans,
supplier by others. Stainless steel immersion heater(s) installed in
bottom for wet only heating operation.
Exterior Body
Exterior body is constructed of 18-gauge stainless steel side panels and
14-gauge galvanized bottom. All exterior side panels are reinforced with
overlapping corners and are welded in place. All body cutouts are
reinforced with 14-gauge galvanized channel supports.
Casters
Casters unit is mounted on 5” (13cm) diameter swivel casters with
non-marking polyurethane casters and pate brakes. Overall height of caster
assembly is 6” (15cm)
Delfield SFW-5-NU Standard Features
High density environmentally friendly, Kyto Protocol compliant, Non ODP
(Ozone Depletion Potential polyurethane foam throughout
NSF-4 and NSF7 certified for hot and or cold operation
Wells operate independently for hot or cold operation and vice versa
Stainless steel immersion heaters - one per well
Control panel(s) with 3 way hot/cold/off switch and thermostat for hot
operation
Electronic temperature control
Adjustable pan support for flush mounted hot operation or 2” recessed
cold operation