The Hubbell model JFR is designed by Hubbell to heat or hold food at safe serving temperatures when used with a food rethermalizer or bain-marie. Mounted under a sink or holding vessel and typically set between 140ºF and 190ºF, the Hubbell model JFR provides continuously circulated hot water to efficiently satisfy safe serving requirements and prevent cold spots.
Hubbell JFR-3 Standard Features
The all stainless steel body and base comes standard on every model
Electronic controls provide precise and consistent water temperatures
Digital display for visual confirmation of set point temperature and fault conditions
Equipped with an energy cut-off (ECO) for built-in protection against higher than normal water temperatures
Low water cut off to prevent element burnout
ETL & ETL Sanitation (ANSI-NSF4) listed
Shipped ready to install with all gaskets and fittings
Straight thread, screw-type elements with o-ring gasket for easy replacement
Separate sump and heating compartment drains allow for easy cleaning and sanitizing
Standard 2" plumbing fittings for mounting into a holding vessel