Insinger CA-3 36" Door Type Pot/Pan/Utensil Dishwasher
Insinger CA-3 Standard Features
Automatic door type utensil washer with timed wash and rinse cycle
Capacity- 25 24" x 28" racks per hour or 150 bun/pans per hour or 100
steam table (2" thick) pans per hour
Fully automatic operation with power on/off button
Cycle starts when doors are closed
Rinse pressure regulator
Hold-Down Rack System for secure washing
Rollers make getting large racks in and out easier
CA-3 is available for corner operation
Wash tank heat: electric, steam injection
Pressure regulator
Single point electrical connection
Low water protection
Door safety switches
1 vent opening with adjustable damper
Inspection door
Vacuum breaker on all incoming water lines
Capillary thermometer for wash and final rinse
304 stainless steel construction
Stainless steel front panel
Automatic fill
Detergent connection provision
Hold-down rack system
Manual bypass selector switch
Side-mounted control panel (NEMA 12)
Simplified scrap screen design
Interchangeable upper and lower spray arms
Standard frame drip proof motor
Rack assortment- 1 general utility, 1 bake sheet, 1 basket
Manifold clean-out brush
SureFire® Start-Up & Check-Out Service
Insinger CA-3 Specifications
CONSTRUCTION- Hood and tank constructed of 14 gauge 18-8 type 304 S/S.
Hood unit of all welded seamless construction. S/S frame, legs and feet.
All internal castings are non-corrosive lead free nickel alloy or
bronze.
DOORS- A front inspection/clean-out door and two simultaneously opening
operating doors. Operating doors balanced by externally mounted springs.
Extra large die formed 18-8 type 304 S/S doors ride in all S/S channels.
A triple ply leading edge on the door channels made of S/S.
PUMP- Centrifugal type “packless” pump with a brass petcock drain.
Construction includes ceramic seal and a balanced cast impeller on a
precision ground stainless steel shaft, extension or sleeve. All working
parts mounted as an assembly and removable as a unit without disturbing
pump housing. One 5 hp motor, standard horizontal C-face frame, drip
proof, internally cooled with ball-bearing construction.
CONTROLS- Side-mounted control cabinet, NEMA 12 rated, housing motor
controls and overload protection, transformer, contactors and all
dishwasher integral controls. All controls safe low voltage 24 VAC.
SPRAY SYSTEM- Wash and rinse spray systems made of 18-8 type 304 S/S
pipe threaded into cast hub assemblies. Upper and lower spray assemblies
are interchangeable and are removable without the use of tools
WASH- 2 power spinning wash arms above and 2 power spinning wash arms
below, each designed with 8 high pressure action cleansing holes.
FINAL RINSE- 2 power spinning wash arms above and 2 power spinning rinse
arms below, each designed with 3 nozzles
DRAIN- Drain valve externally controlled. Overflow assembly with skimmer
cap is removable with the use of simple tools for drain line inspection.
Heater is protected by low water level control.