Heavy Duty banquet service cabinets for pre-plated foods designed by
SecoSelect to meet the rugged use of commercial food service operations.
SecoSelect BQ60 Standard Features
Stainless steel interior and exterior
Fully insulated for energy efficiency
Cabinet is welded steel frame all vertical and horizontal edges for
structural integrity
Caster mounting plates 5/16” steel plate drilled and tapped welded to
cabinet frame
All hardware mounted through framing
Top mounted electronic control with digital dis- play for temperature at
a glance
60 to 230 degree temperature range
Armor Heat™ system
Heavy duty 5” casters standard
Electric and canned fuel operation, standard
Canned heat has its own drawer, no open flames in interior
Doors have 3 hinges standard
18 gauge stainless steel removable perforated shelves, standard
Inner cabinet has 18 gauge stainless steel full perimeter shelf brackets
welded in place
Four chrome plated handles, 2 per end
SecoSelect BQ60 Specifications
GENERAL: Cabinet constructed throughout with stainless steel. All double
wall construction, insulated with high density fiberglass insulation.
All exterior surfaces shall be ground and polished to a #3 finish.
INTERNAL FRAME: All vertical and horizontal edges framed with 1/8” angle
steel, arc welded, cross braced and reinforced at all corners. Welded
steel framing is powder coated.
BASE FRAME: Base shall be 1/8” powder coated steel with formed edges.
Base shall have 4 - 6” x 6” and 5/16” steel plates drilled and tapped to
accommodate 5”, 6” and 8” casters. These plates are fully welded on
three sides 6” to framing.
INNER CABINET: Inner cabinet shall be all 24 gauge 300 series stainless
steel. Inner cabinet shall have 20 gauge stainless steel perforated
removable shelves. These shelves are held in place by a full perimeter
20 gauge stainless steel offset bracket. This bracket is welded to
interior, and has mitered corners heli-arc welded together. This inner
cabinet shall be heated by the Armor Heat™ system. Canned fuel drawer
not exposed to interior of cabinet.
DOORS: Door shall be all 20 gauge stainless steel. Door shall have full
interior frame constructed of 16 gauge galvanized steel angle. Door
shall be fully insulated and gasketed. Doors shall have an exterior
louver with an interior damper for moisture control. All door hardware
shall be secured through framing in cabinet and door. Door shall have a
heavy-duty positive and magnetic door latch and 3 refrigeration type
door hinges.
ELECTRICAL CHARACTERISTICS: Cabinets shall have a top mounted control
panels consisting of an on and off switch with power indicator light.
Electronic controller with digital temperature display. Each cabinet
shall be heated by a 120 volt 60 cycle 1 phase heating system. Cabinets
shall come complete with a permanently mounted 8’ cord with a Nema
#5-20P plug. Top of cabinet is removable for easy access to controls.
CASTERS: Cabinet shall have 4 heavy duty 5” casters, 2 rigid and 2
swivel casters mounted to 6” x 6” x 5/16” steel plate drilled and
tapped. Cabinet shall have a full wrap around rubber bumper. Bumper
mounted to bottom of cabinet frame. Bumper extends past all hardware and
body of cabinet. (Note: Models BQ150 and BQ200 come standard with 5” x
2” casters)