Designed by SecoSelect to accommodate 12” x 20” pans
SecoSelect C12UP Standard Features
All stainless steel construction
Fully insulated
Cabinet is fully framed all vertical and horizontal edges
Caster mounting plates fully welded to cabinet framing
Caster mounting plates 6” x 6” x 5/16” steel plate drilled and tapped
All hardware mounted through framing
Door framed, insulated and gasketed
Door louvered with adjustable damper
Top mounted control panel
60 to 230 degree temperature range
Armor Heat™ system
5” casters standard
Low power requirements
Pan guides permanently mounted
Accommodates 12” x 20” pans in 2”, 4” or 6” depth
Accommodates 1/2” and 1/3” size pans
SecoSelect C12UP Specifications
GENERAL: Cabinet constructed throughout with stainless steel. All double
wall construction, insulated with high density fiberglass insulation.
All exterior surfaces shall be ground and polished to a #4 finish.
INTERNAL FRAME: All vertical and horizontal edges framed with a
combination of 1 1/2” x 1 1/2” x 1/8” angle steel, arc welded, cross
braced and reinforced at all corners.
BASE FRAME: 1/8” formed steel base. Base shall have, four 6” x 6” x
5/16”, steel plates drilled and tapped to accommodate 5”, 6” or 8”
casters. The plates are fully welded to frame on all four sides
INNER CABINETS: Inner cabinets shall be all 24 gauge 300 series.
Stainless steel inner cabinet shall have permanently mounted pan rails.
Rails shall accommodate 12” x 20” x 2 1/2” pans or multiples of 4” and
6” pans. Cabinet will also accommodate 1/2” and 1/3” size pans. Inner
cabinet fully insulated with high density fiberglass; 2” on sides and
back, 4” on top and bottom. Inner cabinet shall be heated by the Armor
Heat™ system.
DOORS: Door shall be all 20 gauge stainless steel. Door shall have full
interior frame constructed of 3/4” x 3/4” 14 gauge galvanized angle
steel. Door shall be fully insulated and gasketed. Doors shall have an
exterior louver with an interior damper for moisture control. All door
hardware shall be secured through framing in cabinet and door. Door
shall have a heavy-duty positive and magnetic door latch and heavy duty
refrigeration type door hinges.
ELECTRICAL CHARACTERISTICS: Cabinets shall have a top mounted control
panel consisting of an on/off switch with power indicator light, and
electronic control with digital temperature display. Cabinet shall be
heated by a 120 volt, 60 cycle, 1 phase heating system. Cabinets shall
come complete with a permanently mounted 8’ cord with a Nema #5-15P
plug. Top of cabinet is removable for easy access to controls.
CASTERS: Cabinet shall come complete with 4-5” casters, 2-rigid and
2-swivel casters mounted to 6” x 6” x 5/16” steel plate drilled and
tapped.