The Southbend Heavy-Duty Counterline products are designed for medium to
heavy-duty applications. Southbend's counterline offers unsurpassed performance,
combining proven control systems with Southbend quality and durability.
Southbend HDG-72 Features
HDG-72: 72" Thermostatic Griddle - Heavy Duty
Counterline - Gas - 180,000 BTU
Available in 18”, 24”, 36”, 48”, 60” and 72” widths
30,000 BTU (NAT or LP) burner per 12” Thermostatic Models
20,000 BTU (NAT or LP) burner per 12” Manual Models
Electronic spark ignition (battery)
Stainless steel front, vent and sides are standard, rear and bottom
panels are aluminized steel.
Reinforced, insulated double wall sides
1” thick polished rolled steel plate
5” high rear and 4” side splash guards
3/4” rear gas connection and pressure regulator
Protected flue opening
Exclusive “NO COLD” Zone -Uniform heat distribution across surface
Each burner equipped with runner tube
Grease drawers with large capacity
Fully welded griddle plate with protected exhaust vent
“Insta-on” thermostatic controls for precise settings between 200°F and
400°F
Imbedded load sensing thermostat
Flame failure safety device
Southbend HDG-72 Specification
Exterior Finish: Front, sides and vent are constructed
of #3 polished 430 and 304 stainless steel. Bottom and rear are
aluminized steel. Sides are reinforced and fully insulated. 5” rear and
4” side splash.
Griddle Plate: 18”, 24”, 36”, 48”, 60”, 72” wide unit
with one 30,000 BTU (NAT or LP) burners every 12” on thermostatic models
and one 20,000 BTU (NAT or LP) burners every 12” on manual models. Fully
welded, 1” thick polished steel griddle plate with side splash guards,
and grease drawer.
Griddle Controls: Independent, “Insta-on” thermostatic
controls with uniform temperature range of 200°F to 400°F. (Thermostatic
models ONLY)
Legs: Stainless steel 4” adjustable legs.
Gas Heat Control System: Each foot of griddle is heated
by a “U” shaped burner. Each burner is controlled by a thermostatic
control. For safety, each pilot has a flame failure device. A 3/4” rear
gas connection is standard. Units over 48” wide are constructed of two
bodies.(Thermostatic models ONLY)