Delfield F17OS Equipment Stand
Standard Features
- Top is stainless steel, with integral front marine edge
- Standard units have unfinished ends
- Stainless steel cutting board brackets with 1.25” thick x 9.50” deep maple cutting board
- 14-gauge leg rails that run the entire length of the unit
- Stainless steel bottom shelf
- 6.12” adjustable full stainless steel legs and bullet feet
Specifications
- Top is constructed of stainless steel, with integral front marine edge nosing and rear backsplash. Spline bars are made of stainless steel and run front to back on both the left and right stainless steel sides for support and spline purposes. Two pieces of C-channel are welded and glued with construction adhesive to the under side of the top for strength and sound deadening. As a standard, cutting board brackets are attached to each side and house a 1.25” thick x 9.5” deep maple cutting board.
- Base is constructed of stainless steel sides. One bottom shelf constructed of stainless steel with double hemmed nosing is spot welded between the sides and braced for extra support.
- Unit is supported with two leg rails that run the entire length of the unit. Leg rails are welded to the bottom side of the unit and are tied together with two braces running front to back. Caster/leg boxes are welded inside the leg rail and 6.12” adjustable legs are mounted as standard with (4) 5/16” bolts.
From The Manufacturer
Equipment Stand, available in lengths of 36" to 96"W (see configuration), open base with bottom shelf, stainless steel legs and undershelf, unfinished ends & back, 9.5" composite cutting board, NSF (contact factory for price)
