0% Interest for 30 Days
The Delfield N8768ND Narrow Drop-In Individually Controlled Electric Food Wells
Why Use Delfield's Drop-In?
Safety and Sanitation
UL and NSF - All Delfield Drop-in products are UL approved and NSF certified. Which means you can count on safe, consistent construction and performance every time.
Convenience
Delfield Drop-in products are easy to install into any new or existing counter. A press fit flange gasket comes pre-installed making the units ready to drop-in immediately.
Quality
Delfield Drop-in products have an unmatched level of quality. The units are reliably built by the best in the industry and come standard with a 90-day labor and 1-year parts warranty
Construction
Delfield Drop-in products are constructed with stainless steel tops and
interiors. Cold units are insulated with high-density polyurethane foam
and hot units are insulated with fiberglass.
Refrigeration lines are secured to the liner with stainless steel spot
clips and thermal transfer compound is applied to improve heat transferred
cool the food product better.
Delfield N8768ND Standart Features
- Individual digital temperature controls standard wired to one main control panel with 4’ of conduit and wire. Field install control panel at location
- N8768ND: Three food wells with drains
- Top is constructed of 18-gauge stainless steel
- Flush mounted die stamped drawn 12” x 20” individual 20-gauge wells
- Wells depressed slightly into the top to hold in condensation
- Standard 1/2” stainless steel drain(s)
- Non-marring press fit top gasket
- Must be hard wired in the field
- Wet and dry operation
- 11.87” x 19.87” individual hot food wells
- Models with drains are manifolded together standard to one main gate valve
- Unit shall be insulated on the bottom and all sides with 1” of fiberglass and bottom to have 2” of fiberfrax blanket insulation
- Galvanized exterior body
- One year parts and labor warranty
Delfield N8768ND Specification
Top shall be one-piece 18-gauge stainless steel, with 0.63” overhang
around perimeter and die stamped 19.87” x 11.87” (50.5cm x 30cm) openings
with depressed edges. Formed well below each opening shall be 6.25” (16cm)
deep. Each well shall have an individual infinite control and 1000 watt
heating element attached to bottom of well. Exterior housing shall be
20-gauge galvanized steel. Unit shall be insulated on sides and between
wells with 1.00” (2.5cm) fiberglass; bottom shall have 1.00” (2.5cm)
blanket insulation.
Unit shall have all individual controls wired to a control panel for
mounting in counter or at a remote location; 4’ (1.2 m) length of wiring
and conduit are provided. Unit shall have a three-wire electrical junction
box to allow hard-wiring at installation.Models with drains are manifolded
together standard to one main gate valve.
