Ensign Dishwasher, Hood Type, high temperature, no booster, straight-thru design, approximately 43 racks/hour capacity, stainless steel construction, electric or steam tank heat, drop-into table top, 1/2 HP, ETLus, Made In USA
Automatic counter type single tank dishwasher with pass-thru telescoping
Capacity is 43- 16" x 16" racks per hour or 720 dishes
No venting required
A timed wash and rinse cycle
Fully automatic operation with power on/off button
Cycle starts when door is closed
Tank heat: electric immersion heater
Thermometer for wash
Thermometer for final rinse
Manifold clean-out brush
Automatic tank fill
Low water protection
Detergent connection provision
Space saving compact design
Fully automatic operation
Side mounted control panel (NEMA 12)
Simplified scrap screen design
Standard frame drip proof motor
Door safety switch
SureFire® Start-Up and Check-Out Service
Insinger ENSIGN 40-2 Specifications
CONSTRUCTION- Hood and tank constructed of 16 gauge type 304 S/S. Hood
unit of all welded seamless construction. All internal castings are
non-corrosive lead free nickel alloy or bronze.
DOORS- Two opening operating doors. Operating doors have fingertip
control, rotating on S/S bracket. Doors formed of 18 gauge S/S.
PUMP- Centrifugal type “packless” pump with a brass petcock drain.
Construction includes ceramic seal and a balanced cast impeller on a
precision ground stainless steel shaft, extension or sleeve. All working
parts mounted as an assembly and removable as a unit without disturbing
pump housing. One 1/2 hp motor, standard horizontal C-face frame, drip
proof, internally cooled with ball-bearing construction.
CONTROLS- Side-mounted control cabinet, housing motor controls and
overload protection, transformer, contactors and all dishwasher integral
controls. All controls safe low voltage 24 VAC.
SPRAY SYSTEM- Wash and rinse spray systems made of 18-8 type 304 S/S
WASH- Power wash arm above with 14 high pressure action cleaning slots
and 6 power wash arms below, each designed with 5 high pressure action
cleansing slots. The slots are precision milled for water control
producing a fan spray. Wash arms are removable without the use of tools.
FINAL RINSE- 1 spray body above designed with 4 power rinse nozzles and
1 power rinse coil below designed with 6 nozzles
DRAIN- Overflow assembly with skimmer is removable without use of tools
for drain line inspection. Heater protected by low water level controls.