CONSTRUCTION: Heavy duty, high tensile,
extruded aluminum. Type 6063-T5 alloy.
UPPER FRAME & TOP: The upper frame is
constructed of vertical uprights 1” x 2 1/2” x 1/8” thick
extruded aluminum channels with top cross and
side bracing of 1 1/4” x 1 1/4” x .070 wall extruded
aluminum tubing, all fully welded together. A solid
cap of .063 thick aluminum is welded to uprights and
cross bracing.
TRAY SLIDES: Slides are 1 1/4” x 1 5/8” x .100” thick
extruded aluminum angle with 1 1/4” lip on front end.
REAR PANEL: Rear panels is .080 thick aluminum
panels with corrugation on each side for strength
and enhanced air circulation. Panel is welded to the
top, bottom, and rear vertical uprights.
DOOR: Custom extruded aluminum frame with
polycarbonate insert. The door is supported by
three stainless steel hinges designed to provide
270° door swing. A positive gravity catch is provided
to retain door in a closed position.
SIDES: Covered with 1/8“ thick polycarbonate that
bolts to aluminum uprights.
TIE ROD: A 1” x 1” x .070 wall extruded aluminum
tube tie rod is welded to the front vertical upright for
extra rigidity.
BOTTOM FRAME: Bottom frame is constructed of
1/8” thick aluminum sheet with four sides bent down
1 5/8”, all corners welded smoothly. Tubular
framework welded inside the 1 3/8” aluminum sheet for
extra rigidity. Caster plates (2 3/4” x 4“ x 3/8” thick
pre-tapped) are welded to bottom of frame.
CASTERS: Four platform type 5” casters, full
swivel design with sealed ball bearing axle and
non-marking wheel.
The image above may not exactly represent the product
