Resources
Brand | Delfield |
---|---|
Model Number | 402P |
Weight | 176 lbs |
Width | 27.25" |
Depth | 28.5" |
Height | 39.5" |
Sections | 1 section |
Refrigeration | self-contained, rear mounted |
Exterior Finish | stainless steel top, front & sides |
Interior Finish | stainless steel & ABS |
Access Type | doors |
Number of Doors | 1 door |
Compressor HP | 1/5 HP |
Special Features | with backsplash |
Capacity (cu. ft.) | 5.7 |
Compressor Style | side / rear breathing |
Door Type | solid door |
Exterior bottom shall be heavy-gauge galvanized metal. Exterior ends shall
be heavy-gauge stainless steel.
Exterior top one-piece, 22-gauge stainless steel with front edge turned
down to form nosing and rear edge turned up to form a 2” (5.1 cm) thick by
4” (10.2 cm) high backsplash.
Door shall have a heavy-gauge stainless steel exterior, with a thermoformed ABS plastic interior liner, and shall be fully insulated with foamed-in-place polyurethane. Door handles shall be black, recessed ABS. Cabinet shall have (1) adjustable epoxy-coated wire shelves installed. Equipment shall be mounted on 6” (15.2 cm) high metal legs with black enamel finish.
One-piece thermoformed ABS plastic material, with integral shelf supports. Base shall be fully insulated with high-density foamed-in-place environmentally friendly, Kyoto Protocol Compliant, Non ODP (Ozone Depletion Potential), Non GWP (Global Warming Potential) polyurethane.
115 volt, 60 Hertz, single phase. Unit shall have a 6’ (1.8 m) long electrical cord and NEMA 5-15P plug. Cord and plug shall be located on the rear of the cabinet 16” (40.6cm) above floor, 5” from left side.
Refrigeration system shall use R290 refrigerant. Compressor shall be 1/5 h.p., with condenser coil and hot gas condensate evaporator mounted on rear of cabinet. Evaporator coil shall be mounted on the interior rear wall of the cabinet. Temperature control is mounted to the exterior rear of the cabinet. Refrigerant flow shall be controlled by a capillary tube. Cabinet shall maintain 36°F to 40°F (2°C to 4°C) interior cabinet temperature. System is controlled using Delfield’s ACT-Advanced Control Technology electronic temperature control, which provides improved pull down times, reduces compressor cycling and longer compressor life with lower energy consumption.